Change checkpoint to calculate number of blocks required instead of using a hardcoded...

[yaffs2.git] / Kconfig

diff --git a/Kconfig b/Kconfig
index 272df72213a4f823c8c266e4dd202d839c6fbcac..b2b3bc52a754f8560f686a31d42f75b063ebdaa9 100644 (file)
--- a/Kconfig
+++ b/Kconfig
@@ -110,26 +110,6 @@ config YAFFS_DISABLE_LAZY_LOAD
 
          If unsure, say N.
 
-config YAFFS_CHECKPOINT_RESERVED_BLOCKS
-       int "Reserved blocks for checkpointing"
-       depends on YAFFS_YAFFS2
-       default 10
-       help
-          Give the number of Blocks to reserve for checkpointing.
-         Checkpointing saves the state at unmount so that mounting is
-         much faster as a scan of all the flash to regenerate this state
-         is not needed.  These Blocks are reserved per partition, so if
-         you have very small partitions the default (10) may be a mess
-         for you.  You can set this value to 0, but that does not mean
-         checkpointing is disabled at all. There only won't be any
-         specially reserved blocks for checkpointing, so if there is
-         enough free space on the filesystem, it will be used for
-         checkpointing.
-
-         If unsure, leave at default (10), but don't wonder if there are
-         always 2MB used on your large page device partition (10 x 2k
-         pagesize). When using small partitions or when being very small
-         on space, you probably want to set this to zero.
 
 config YAFFS_DISABLE_WIDE_TNODES
        bool "Turn off wide tnodes"